Get your Sole Mate SM‑76C automatic shoe cover machine up and running in just a few minutes. For full details, see the User Manual.
1. Before You Start
- •Place the machine on a flat, stable, dry floor.
- •Use only approved Sole Mate SM‑76C film rolls.
- •Do not use the machine barefoot – always wear socks or shoes.
- •Keep hands, fingers, and loose clothing away from moving parts.
2
Set Up the Machine
Unpack
- Remove the SM‑76C and power cord from the box.
- Check for visible damage. If anything looks damaged, contact Sole Mate before use.
Position
- Place the machine where people can step in and out safely.
- Leave clear space in front and behind the machine.
Power
- Make sure the power switch is OFF.
- Plug the power cord into the machine and then into a wall outlet.
- Turn the power switch ON. The display/indicator should light up.
3
Load the Film Roll
- 1Turn the machine OFF and unplug it.
- 2Open the film loading cover.
- 3Remove any used roll or loose film.
- 4Insert a new Sole Mate SM‑76C film roll in the holder, following the direction shown on the roll/inside label.
- 5Pull the film across the foot placement area as shown in the diagram on the machine.
- 6Close the cover, plug the machine back in, and turn it ON.
4
Apply Shoe Covers
- 1Stand directly behind the machine, facing forward.
- 2Place one foot straight down into the foot opening, keeping it centered.
- 3Hold still for about 3 seconds while the film wraps and shrinks.
- 4Lift your foot straight up and out.
- 5Repeat with your other foot.
Tips
- Step straight in and straight out; avoid twisting.
- Walk normally, but don't run or drag your feet.
- If a cover looks incomplete or loose, remove it and apply a new one.
5
If Something Isn't Working
Machine won't turn on
→ Check power cord, outlet, and power switch.
No film applying
→ Check that the roll is installed correctly and not empty.
Film jam
→ Turn OFF, remove jammed film carefully, reload, and test again.
For more detail, see the User Manual or visit Troubleshooting.